Selfpriming Pumps for Deep Suction APM 100

MYR 910.00

    Selfpriming Pumps for Deep Suction APM 100

    *** APPLICATION ***

    Selfpriming water pumps for deep suctions up to mt. 35 to be used in case of important water level gaps. Suitable to drain water from wells and in domestic fittings by small and medium sized tanks. Before installing the pump verify that all pipes (iron, plastic or rubber) are clean inside so to avoid any obstruction to the ejector nozzle. At the foot of the ejector must be installed a foot valve or a check valve. Installed the pump, fill completely both pipes and pump body with clean water. To preserve an efficient priming it is necessary a certain precision in the circuit, therefore it is recommended to install a membrane tank at the delivery of the pump.


    *** Features ***


    • Liquid temperature up to 35°C

    • Ambient temperature up to 40°C

    • Total suction lift up to 35 mt.

    • Continuous duty


    • Two-Pole induction motor (n = 2850 min-1)

    • Insulation Class F

    • Protection IP 44


    • Pump body: Cast Iron

    • Motor support: Aluminium

    • Impeller: Noryl

    • Diffuser: Noryl

    • Ejector: Cast Iron

    • Shaft with rotor: Stainless Steel AISI 304

    • Mechanical seal: Ceramic/Graphite/NBR


    *** Technical data ***

    Specification Description
    Nominal Power P2 (HP) 1
    Nominal Power P2 (kW) 0.75
    Total Head (M) 38
    Capacity (L) 35
    Suction Depth (M) 15
    Inlet x Outlet 1-1/4 inch x 1 inch
    Power 1Ø, 230v, 50Hz